Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
Handle
1
Bolt (5/16 x 7/8 inch)
2
Bolt (5/16 x 1-1/2 inches)
2
Washer
4
Locknut (5/16 inch)
4
1
Cable tie
3
Install the handle.
Self-tapping screw
2
2
Fuel tank
1
Install the fuel tank and fuel line.
3
No parts required
–
Fill the crankcase with oil.
Note:
Determine the left and right sides of the
machine from the normal operating position.
Step
1
Installing the Handle
Parts needed for this step:
1
Handle
2
Bolt (5/16 x 7/8 inch)
2
Bolt (5/16 x 1-1/2 inches)
4
Washer
4
Locknut (5/16 inch)
3
Cable tie
Procedure
1. Mount the handle to the mower housing with
2 bolts (5/16 x 7/8 inch), 2 bolts(5/16 x 1-1/2
inches), 4 washers, and 4 locknuts (Figure 3).
Figure 3
1. Housing
3. Bolt (5/16 x 1-1/2 inches),
washer, and locknut
2. Handle
4. Bolt (5/16 x 7/8 inch),
washer, and locknut
Note:
Install the washers with the cup side
facing the handle.
Note:
You can adjust the handle height for
more comfortable operation. Securing the
lower handle end in the upper hole lowers the
handle; securing the lower handle end in the
lower hole raises the handle.
2. Use the cable ties provided to secure the
control cables to the handle.
7