Setup
Important:
Remove and discard the protective
plastic sheet that covers the engine.
1. Installing the Blade Control
Bar
Procedure
Install the blade control bar into the upper handle
(Figure 3).
Figure 3
2. Assembling and Unfolding
the Handle
Procedure
Assembling and unfolding the handle
improperly can damage the cables, causing an
unsafe operating condition.
•
Do not damage the cables when assembling
and unfolding the handle.
•
Ensure that the cables are routed to the
outside of the handle.
•
If a cable is damaged, contact an Authorized
Service Dealer.
1. Raise the rear of the mower housing to its highest
cutting height setting by moving the 2 rear cutting
height levers all the way forward. Refer to Adjusting
the Cutting Height in the Operation section.
2. Attach the handle ends to the mower housing with
2 washers and 2 handle bolts (Figure 4),
but do not
tighten the handle bolts.
Figure 4
1.
Washer
3.
Handle end
2.
Handle bolt
Important:
Route the cables to the
outside
of
the handle (Figure 4).
3. Rotate the handle rearward (Figure 5).
Figure 5
4. Lock the handle at your desired height. Refer to
Adjusting the Handle Height in the Operation
section.
5
Summary of Contents for 20093
Page 20: ...Notes 20 ...
Page 21: ...Notes 21 ...
