4.
Slowly
pour oil into the oil fill tube until the oil level
reaches the Full line on the dipstick (Figure 30).
Do
not overfill.
(Max. fill: 20 oz. (0.59 l), type: SAE
30W detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher.)
Figure 30
5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling
center.
Lubricating the Wheel Gears
Service Interval:
Yearly
Self-propel models only
1. Wipe the grease fittings just inside the rear wheels
with a clean rag (Figure 31).
Figure 31
2. Install a grease gun onto each fitting and gently apply
2 or 3 pumps of #2 multi-purpose lithium-base
grease.
Replacing the Blade
Service Interval:
Every 25 hours—Replace the blade
or have it sharpened (more frequently
if the edge dulls quickly).
Important:
You will need a torque wrench to install
the blade properly
. If you do not have a torque
wrench or are uncomfortable performing this
procedure, contact an Authorized Service Dealer.
Examine the blade whenever you run out of gasoline. If
the blade is damaged or cracked, replace it immediately.
If the blade edge is dull or nicked, have it sharpened or
replace it.
The blade is sharp; contacting the blade can
result in serious personal injury.
Wear gloves when servicing the blade.
1. Disconnect the spark plug wire from the spark plug.
Refer to Preparing for Maintenance.
2. Tip the mower onto its side with the air filter up.
3. Use a block a wood to hold the blade steady
(Figure 32).
Figure 32
4. Remove the blade, saving all mounting hardware.
5. Install the new blade and all mounting hardware.
13
Summary of Contents for 20090
Page 16: ...Notes 16 ...
Page 17: ...Notes 17 ...
