Toro 139-6655, Installation Instructions Manual, Page: 10 / 12

9
Installing the Kickers
For 72-inch Mower Decks
Parts needed for this procedure:
2 Kickers
4 Carriage bolt (5/16 x 7/8 inch)
4 Locknut (5/16 inch)
Procedure
Install and secure the kickers using 4 carriage bolts
(5/16 x 7/8 inch) and 4 locknuts (5/16 inch) as shown
in
Figure 11 .
g016204
Figure 11
1. Carriage bolts (5/16 x 7/8
inch) 2. Kickers
10
Tightening all the Fasteners
No Parts Required
Procedure
1. Tighten all nuts and bolts for the baffles; refer to
the Installing the Baffles sections.
2. For GrandStand mowers, lower the machine,
remove the plastic from the hydraulic tank, and
connect the battery.
3. For GrandStand mowers, place the battery
onto the machine.
4. Secure the battery with the hold-down plate,
J-bolts, and locknuts.
5. Install the positive (red) battery cable to positive
(+) battery terminal with a nut, washer, and bolt.
Slide the rubber cover over the post.
6. Install the negative battery cable and ground
wire to the negative (-) battery terminal with a
nut, washer, and bolt.
Slide the rubber cover over the post.
11
Installing the Recycler
Blades
Parts needed for this procedure:
3 Recycler blade (sold separately)
Procedure
1. Install the 3 recycler blades; refer to the
Operator’s Manual .
2. Rotate the blades and ensure that there is
clearance between the blades and baffles.
If there is interference, loosen the baffle and
reposition it.
10