Figure 3
1.
Bolt, (3/8 x 1 inch)
3.
Right side of machine
2.
Handle assembly
2. Fasten the cables to the machine with a plastic tie
(Figure 4). Ensure the cables do not contact the
rear tire.
Figure 4
1.
Handle assembly
2.
Plastic cable tie
4
Installing the Handle to a Z
Master
®
G3 Mower
Parts needed for this procedure:
1
Handle assembly
2
Bolt, (3/8 x 1 inch)
1
Plastic cable tie
1
Adhesive back mount
Procedure
1. Install the handle assembly to the right side of the
machine with 2 bolts (3/8 x 1 inch) (Figure 5).
Figure 5
1.
Bolt, (3/8 x 1 inch)
3.
Right side of the machine
2.
Handle assembly
2. Install the adhesive back plastic mount on a smooth
clean surface. Thread the cable tie through the
plastic mount and secure the cables with the cable
tie (Figure 6).
4
