Toro 117-0354, Installation Instructions Manual, Page: 4 / 8

Figure 2
1. Carriage bolt (3/8 x 1-1/4
inches) 5. Bottom bracket (48,52 and
60 inch mowers)
2. Z Stand hub (48,52 and
60 inch mowers) 6. Z Stand hub (72 inch
mowers)
3. Right side of machine 7. Angle bracket
4. Flange nut (3/8 inch) 8. Bottom bracket (72 inch
mowers)
Figure 3
72 inch hub only
1. Z Stand hub installed (72
inch mowers) 3. Right side of machine
2. Angle bracket (72 inch
mowers)
3
Installing the Z Stand Bracket
Parts needed for this procedure:
2 Carriage bolt (3/8 x 1-1/4 inches)
2 Flange nut (3/8 inch)
1 Bolt (1/4 x 3/4 inches)
1 Locknut (1/4 inch)
1 Bracket pin
1 Lanyard
1 Cradle bracket
Procedure
Note:
Ensure the grass deflector is installed in the lower
holes in the mower deck brackets.
1. Place the Z Stand cradle bracket onto the left front
frame as shown in Figure 4.
2. Install the Z Stand cradle bracket to the frame with the
cradle bracket, 2 carriage bolts (3/8 x 1-1/4 inches)
and 2 flange nuts (3/8 inch)(Figure 4).
Ensure the correct holes are used as shown in Figure 4.
3. Install the lanyard to bracket pin. Use large loop on
lanyard (Figure 4).
4. Install the lanyard with a bolt (1/4 x 3/4 inches) and
locknut (1/4 inch) (Figure 4).
4