Toro 08731, Operator'S Manual

Page: 1 / 16

Form No. 3372-400 Rev C
Midmount Toolbar System
Sand Pro ® /Infield Pro ® 3040 and 5040 Traction Unit
Model No. 08731—Serial No. 312000001 and Up
Operator's Manual
Important:
Before installing the mid-mount toolbar system, you should obtain one of the toolbars available for use
with the system. For more information, contact an Authorized Toro Distributor.
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
No parts required
–
Do the pre-installation setup.
Bolt (5/16 x 2-1/4 inches) 2
Nut (5/16 inch) 2
Scarifier lift-handle assembly 1
Bolt (1/2 x 3-1/4 inches) 2
Thin locknut (1/2 inch) 2
Detent plate 1
2
Knob 1
Install the scarifier lift-handle assembly.
Pivot tube 1
Extension spring 1
Spring rod 1
Pivot tube bracket 2
Bolt (3/8 x 3 inches) 4
Locknut (3/8 inch) 6
Spring bracket 1
3
Bolt (3/8 x 2-3/4 inches) 1
Install the pivot tube and the tension
spring.
Adjustable rod assembly 1
Bolt (1/2 x 1-1/2 inches) 1
4
Locknut (1/2 inch) 2
Install the adjustable rod assembly.
Screen panel 1
Pan-head screw (#10 x 1/2 inch) 2
Right-hand saddle assembly 1
Left-hand saddle assembly 1
Bolt (5/16 x 1 inch)
4
5
Locknut (5/16 inch) 4
Install the screen panel and saddles.
6
Toolbar (sold separately) 1 Install a toolbar.
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3372-400* C