Lubrication
Greasing the Bearings and
Bushings
Service Interval:
Every 100 hours (lubricate
more frequently in heavy-duty
applications).
Grease Type:
No. 2 lithium grease
1.
Use a rag to wipe the grease fitting clean so that
foreign matter cannot be forced into the bearing
or bushing.
2.
With a grease gun, apply grease into the grease
fittings on the machine.
3.
Wipe any excess grease off the machine.
Important:
When greasing the drive shaft
universal shaft bearing crosses, pump grease
until it comes out of all 4 cups at each cross.
The grease fitting locations and quantities are as
follows:
•
Ball joints (4)
; refer to
•
Tie rods (2)
; refer to
•
Pivot mounts (2)
; refer to
•
Steering cylinder (2)
; refer to
g010360
Figure 29
•
Spring tower (2)
; refer to
g010571
Figure 30
•
Clutch (1)
; refer to
•
Accelerator (1)
; refer to
•
Brake (1)
; refer to
g002394
Figure 31
•
U-joint (18)
; refer to
•
4-wheel drive shaft (3)
; refer to
38
Summary of Contents for 07385TC Workman HDX-D
Page 39: ...g010359 Figure 32 39...
