Toro 07324, Installation Instructions Manual

Page: 6 / 8

6. Remove the rear bolt and nut that secure the dash to
the front frame support on the left side of the machine
(
Figure 3 ).
Note:
Retain the rear bolt and nut.
7. Loosely install the front supports to the floor of the
machine (
Figure 3 ).
Important:
On the left side, use the existing nut
just removed and bolt (5/16 x 1 inch).
On the right side, use a bolt (5/16 x 1 inch) and
flange nut (5/16 inch) from loose parts. Secure the
bottom of both tubes to the machine floor using
the carriage bolts (5/16 x 3/4 inch) and flange
nuts (5/16 inch).
8. Locate the canopy top in loose part. Locate and
remove the assembled clinch nut, washer, and bolt
securing the rear cross bar of the internal canopy frame
to the canopy. Retain these parts for installing the
canopy top to the rear support frames.
9. If your machine has a ROPS, mount the clinch nuts
into the holes in the ROPS (
Figure 8 ).
10. Lift the canopy onto the support frame, and loosely
install the canopy to the front supports using 4 screws
(5/16 x 2-3/4 inches), 4 flat washers (5/16 inch), and 4
flange nuts (5/16 inch) as shown in
Figure 6 .
Note:
The canopy support is already loosely installed
to the canopy ( Figure 6 ).
G009289
2
5
1
4
3
5
6
g009289
Figure 6
1. Canopy 4. Screw (5/16 x 2-3/4
inches) and washer (5/16
inch)
2. Right, front support 5. Flange nut (5/16 inch)
3. Left, front support 6. Canopy support
11. Secure the canopy to the rear support frame as follows:
A. If your machine does not have a ROPS, secure the
canopy to the rear support tube using 2 screws
(5/16 x 2 inches), 2 washers (5/16 inch), and 2
flange nuts (5/16 inch) as shown in
Figure 7 .
G009291
1
2
3
4
g009291
Figure 7
Machine without a ROPS
1. Rear support tube 3. Bolt (5/16 x 2 inches) and
washer (5/16 inch)
2. Canopy 4. Flange nut (5/16 inch)
B. If your machine does have a ROPS, secure the
canopy to the ROPS frame using 2 bolts (3/8 x 1
inch) and 2 flat washers (3/8 inch) in the clinch
nuts installed previously (
Figure 8 ).
G009290
1
2
3
4
g009290
Figure 8
Machine with a ROPS
1. ROPS 3. Canopy
2. Clinch nut 4. Bolt (3/8 x 1 inch) and
washer (3/8 inch)
12. Starting at the bottom of the machine and working
your way to the top, tighten all the fasteners.
6