Adjusting the Neutral
Gear-Shift Position
1.
Loosen the jam nuts on the gear-shift cable and
adjust them as necessary (
).
g034455
Figure 60
1.
Shift lever
3.
Gear-shift cable
2.
Spanner bar
4.
Jam nuts
2.
Test the gear-shift position by rotating the
gear-shift selector to the 3 different positions
and check to see if the shift lever (
)
shifts properly when shifting the gears; refer to
Gear-Shift Lever and Gear-Shift Indicator (page
13)
.
3.
Verify that all of the positions are working
correctly by repeating the steps in
Neutral Gear-Shift Position (page 48)
.
Maintaining the Primary
Drive Clutch
Service Interval:
Every 400 hours/Yearly (whichever
comes first)
CAUTION
The dust in the clutch will become airborne
and could damage your eyes or you could
inhale it, causing breathing difficulties.
Wear safety goggles and a dust mask or
other eye and respiratory protection when
performing this procedure.
1.
Raise and latch the cargo bed.
2.
Remove the 3 bolts securing the cover to the
clutch, and remove the cover (
Note:
Retain the cover and bolts for installation.
g011947
Figure 61
1.
Cover
2.
Bolts
3.
Thoroughly clean the inside of the cover and
the inner components of the clutch using
compressed air.
4.
Install the clutch cover and secure it with the 3
bolts (
) that you removed in
.
5.
Lower the cargo bed.
Reducing the Top Speed
CAUTION
The dust in the clutch will become airborne
and could damage your eyes or you could
inhale it, causing breathing difficulties.
Wear safety goggles and a dust mask or
other eye and respiratory protection when
performing this procedure.
1.
Raise and latch the cargo bed; refer to
the Cargo Bed to the Service Position (page 21)
.
2.
Remove the bolts securing the primary clutch
cover as shown in
.
Important:
Use caution when removing
the clutch cover; the spring is under
compression.
Important:
Take note of the X orientation
on the clutch covers and clutch assemblies
for later installation.
49
Summary of Contents for 07059LT
Page 56: ...Notes...
Page 60: ......
