g026341
Figure 62
1.
Clutch spacer
3.
Remove the spring.
4.
Add or remove spacers to adjust the top speed.
Use the following table to determine the amount
of spacers needed.
Spacers
Top Speed
2 (standard)
16 mph (standard)
3
12 mph
4
9 mph
5
6 mph
6
4 mph
Important:
Do not operate the machine
without at least 2 clutch spacers in place.
5.
Install the spring and clutch cover.
Important:
Ensure that the X is placed back
in the original location.
6.
Torque the bolts to 179 to 228 N∙m (132 to 168
in-lb).
Cooling System
Maintenance
Cooling System Safety
•
Swallowing engine coolant can cause poisoning;
keep out of reach from children and pets.
•
Discharge of hot, pressurized coolant or touching
a hot radiator and surrounding parts can cause
severe burns.
– Always allow the engine to cool at least 15
minutes before removing the radiator cap.
– Use a rag when opening the radiator cap, and
open the cap slowly to allow steam to escape.
•
Do not operate the machine without the covers
in place.
•
Keep your fingers, hands and clothing clear of
rotating fan and drive belt.
•
Shut off the engine and remove the key before
performing maintenance.
Cleaning the
Engine-Cooling Areas
Service Interval:
Every 100 hours Clean the cooling
system twice as often during
special operating conditions; refer
to Maintaining the Machine under
Special Operating Conditions.
Important:
Operating the engine with a blocked
rotating screen, dirty or plugged cooling fins, or
cooling shrouds removed causes engine damage
due to overheating.
Important:
Never clean the engine with a pressure
washer because water could contaminate the fuel
system.
Clean the inlet, cooling fins, and external surfaces of
the engine.
Note:
Clean the engine cooling components more
often under extremely dusty and dirty conditions.
50
Summary of Contents for 07059LT
Page 56: ...Notes...
Page 60: ......
