Idler Plate
g395810
Figure 130
1.
Bushing
6.
Adjuster pin (with a 2-lug groomer
gearbox)
11.
Retainer
2.
Idler plate
7.
Cotter pin (with a 2-lug groomer
gearbox)
12.
Shaft
3.
Flange nut
8.
Spring pin (idler plate)—cross drilled
(with a single-lug groomer gearbox)
13.
Shield
4.
Spring pin (idler plate)—threaded
(with a 2-lug groomer gearbox)
9.
Bearing shield
5.
Shoulder screw—threaded (with a
single-lug groomer gearbox)
10.
Bearing
Note:
The groomer idler plate is located at the opposite side of the groomer
gearbox.
Note:
Early universal groomers used 2 non-adjustable compression springs on
eye bolts for the 2-lug gearbox and idler plate. The single-lug gearbox and idler
plate assemblies are the current groomer drive configuration, and use shim
washers to preload the springs; refer to
Removing the Idler Assembly
1. Remove the reel drive from the cutting unit; refer to
.
2. Remove the groomer reel assembly; refer to
(page 8–19)
.
3. Remove the eye bolt of the groomer adjuster from the idler plate as follows:
Universal Groomer (Optional): Service and Repairs
Page 8–16
Greensmaster
®
eFlex 1021
20248SL Rev C
Summary of Contents for 04861
