Toro 04351 Greensmaster 3050, Operator'S Manual

Page: 16 / 48

16
Note: Retain the protective covers for the cutting units.
Install them whenever the reel drive motors are removed to
protect the cutting unit bearings from contamination.
9. Using a hand pump grease gun, fill the cavity at the end
of the cutting unit with #2 general purpose grease.
10.
Coat the spline shaft of the motor with clean grease and
install the motor by rotating the motor clockwise so that
the motor flanges clear the studs. Rotate the motor
counterclockwise until the flanges are encircling the
studs. Tighten the mounting capscrews (Fig. 13).
Rear Ballast
This unit complies with CEN standard EN 836:1997, ISO
standard 5395:1990, and ANSI B71.4–1999 specifications
when 40 lb. of calcium chloride ballast is added to the rear
wheel.
Important If a puncture occurs in a tire with calcium
chloride, remove the unit from the turf area as quickly as
possible. To prevent possible damage to the turf,
immediately soak the affected area with water.