Toro 04063, Installation Instructions Manual

Page: 14 / 16

g032885
Figure 28
Left side of the machine shown
1. Wire harness (machine) 3. Wire harness (LED light
kit)
2. Cable tie
•
eFlex/Flex 1820 and 2120 Series
machines:
Use a cable tie to bundle the remaining
length of the wire harness together (
Figure
29 ).
Note:
Perform this step for both sides of the
machine.
g200973
Figure 29
Left side of the machine shown
1. Installed 2-pin connector
(wire harness—LED light
kit) 2. Cable tie
8
Finishing the Light Kit
Installation
No Parts Required
Installing the Control-Panel Cover
1820 or 2120 Series Machines
1. Align the keyhole slot in the control-panel cover
over the traction and reel drive handle (
Figure
30 ).
g032818
Figure 30
1. Traction and reel drive
handle 3. Flange-head screw (1/4 x
1/2 inch)
2. Keyhole slot (control-panel
cover) 4. Support bracket (handle
bar)
2. Align the holes in the control-panel cover to the
holes in the support bracket of the handle bar
(
Figure 30 ).
3. Assemble the cover to the bracket ( Figure
30 ) with the 4 flange-head screws (1/4 x 1/2
inch) that you removed in 2 Removing the
Control-Panel Cover (page 3) .
14