Toro 03781, Service Manual

Page: 396 / 468

Reelmaster 7000--D
DPA Cutting Units
Page 9 -- 42
Rear Roller Brush -- Optional (cutting units with painted side plates)
2
3
6
8
9
10
11
13
1
5
7
12
14
15
16
17
18
19
20
4
21
22
23
24
25
26
27
28
29
30
6
31
16
16
26 27
29
32
3
33
34
2
1. Roller brush assembly
2. Carriage screw (3)
3. Flange nut
4. Flange bushing
5. Idler spring
6. Excluder seal (2)
7. Bearing assembly (driven)
8. Spacer
9. Hardened washer (as required)
10. Driven pulley
11. Flange nut
12. Carriage screw (2)
13. Cap screw (2)
14. Idler spacer
15. Idler pulley assembly
16. Lock nut
17. Flat washer (4)
18. Drive belt
19. Brush cover
20. Flange head screw
21. Drive pulley
22. Spacer
23. Shoulder bolt
24. Brush plate
25. Idler plate
26. Cap screw (4)
27. Hardened washer (4)
28. Drive bearing housing
29. Mounting bracket (2)
30. Bearing assembly (non--driven)
31. O--ring
32. Socket head screw (2)
33. Pivot washer
34. Set screw (top hole in cover)
Figure 56
Antiseize
Lubricant
FRONT
RIGHT
15 to 19 ft--lb
(20 to 25 N--m)
15 to 19 ft--lb
(20 to 25 N--m)
Grease
Grommet ID
27 to 33 ft--lb
(37 to 44 N--m)
15 to 19 ft--lb
(20 to 25 N--m)
Loctite #243
15 to 19 ft--lb
(20 to 25 N--m)
Loctite #243
35 to 40 ft--lb
(47 to 54 N--m)
NOTE:
Drive components for the rear roller brush are
located on the opposite side of the cutting unit from the
cutting reel hydraulic motor. Figure 56 shows compo-
nents used when the brush drive is on the left side of the
cutting unit.
NOTE: The Installation Instructions for the rear roller
brush kit has detailed information regarding assembly
and adjustment. Use those Instructions along with this
Service Manual when servicing the rear roller brush.