Toro 03781, Service Manual

Page: 247 / 468

Reelmaster 7000−D Page 6 − 21 Electrical System
Number/
Code
Description Condition/Action
160 Start Denied Wait to start until system functions have been initialized
No operator in seat and parking brake is not engaged.
Traction pedal is in FORWARD or REVERSE position
Joystick is in RAISE position
Joystick is in LOWER position
Reel Enable/Disable switch is in ENGAGE position
161 Engage Cutting Unit Denied No operator in seat
Engine coolant temperature is excessive
162 Lower Cutting Unit Denied Speed limiter is in HIGH (transport) position
163 HIGH (transport speed range) Denied Cutting unit position switch is closed (cutting units be-
low turnaround position).
169 Engine Shutdown No operator in seat and parking brake is not engaged.
Parking brake IS engaged while traction pedal is in
FORWARD or REVERSE position
Engine coolant temperature is excessive
Engine oil pressure is low
170 Recycle Keyswitch (ignition switch) Engine starter motor has been engaged for more than
30 seconds or engine start attempt already happened
171 Auto Idle Engaged
(Yanmar diesel engines only)
Engine RPM has been reduced to low idle speed as
machine has been inactive for the set period of time.
Inactive means the traction pedal is in NEUTRAL, reel
enable/disable switch is in DISENGAGED position, joy-
stick is in NEUTRAL position, and engine speed switch
(Yanmar diesel engines) is not pressed.
Auto idle feature timing can be reduced, increased, or
turned OFF as needed.
173 Master Address Claim (TEC)
176 Reel Speed Changed An item on the Setting Screen used to calculate reel
speed has been changed
177 Reel Speed Changed Out of Range
179 Ash Cleaning Warning See Yanmar diesel engine Service Manual
180 New Value Saved in Permanent Memory An item on the Setting Screen has been changed
Table 1: Operator Advisories
Engine running
Version check restriction
or
Sit down or set parking brake
Not in neutral
Raise switch closed
Lower switch closed
Not in seat
Range high engaged
Coolant too hot
Hydraulic oil too hot
Reel Enable/Disable switch enabled
Parking brake is set
Loss of CAN
Key start held too long
Safety kill
Recycle keyswitch
Engine Oil Pressure Low
Table 2: Operator Advisory Qualifiers
Electrical
System