Product Overview
g320359
Figure 33
1.
Front cutting units
4.
Operator's seat
2.
Control arm
5.
Engine hood
3.
Steering wheel
6.
Rear cutting unit
Controls
Brake Pedals
The 2 foot pedals (
) operate individual wheel
brakes for turning assistance and to aid in obtaining
better side hill traction.
g015074
Figure 34
1.
Brake pedal
4.
Traction pedal
2.
Pedal-locking latch
5.
Tilt-steering pedal
3.
Parking-brake pedal
Pedal-Locking Latch
The pedal-locking latch (
) connects the
pedals together to engage the parking brake.
Parking-Brake Pedal
To engage the parking brake, (
) connect the
pedals together with the pedal-locking latch, push
down on the right brake pedal while engaging the toe
pedal.
Note:
When the parking brake is engaged, the
parking brake symbol displays in the InfoCenter.
To release the parking brake, press 1 of the brake
pedals until the parking-brake latch retracts.
Traction Pedal
The traction pedal (
) controls the forward
and reverse operation. Press the top of the pedal to
move forward and the bottom of the pedal to move
backward. Ground speed depends on how far you
press the pedal. For no load, maximum ground speed,
move the engine-throttle control to the fast position
and then fully press the traction pedal
To stop, reduce your foot pressure on the traction
pedal and allow it to return to the center position.
Tilt Steering Pedal
To tilt the steering wheel toward you, press the foot
pedal (
) down, and pull the steering tower
toward you to the most comfortable position and then
release the pedal.
Speed-Limiter Screws
Adjust the screw(s) (
) to limit the amount
the traction pedal can be pressed in the forward or
reverse direction to limit speed.
Important:
The speed-limiter screw must stop the
traction pedal before the pump reaches full stroke
; otherwise, damage to the pump may occur.
g015075
Figure 35
1.
Reverse speed limiter
screw
3.
Spacers
2.
Forward speed limiter
screw
4.
Mow-speed limiter
19
