High HOC Kit:
New front roller brackets and
additional spacers for the rear roller allow the cutting
unit to achieve heights of cut above 25 mm (1 inch).
The new front roller brackets also move the front roller
out farther to improve after-cut appearance.
Shoulder Roller:
Helps reduce overlap marks for
warm season grasses (Bermuda, zoysia, paspalum)
Collar Kit (6 per needed per roller):
Helps reduce
overlap marks for warm season grasses (Bermuda,
zoysia, paspalum); install this kit on the existing
Wiehle roller; it is not as aggressive as the shoulder
roller
Short Rear Roller:
Helps reduce double roller marks
for cool season grasses (bent, bluegrass, rye)
Full Front Roller:
Helps produce more pronounced
striping (repeated cutting in the same direction/path);
however, it raises the effective height of cut and
reduces the quality of cut.
Scrapers (Wiehle, Shoulder, Rear roller, Full Front
Roller):
Fixed scrapers for all optional rollers are
available for reducing grass buildup on rollers, which
can affect height-of-cut settings.
Roller Rebuild Kit:
Includes all the bearings, bearing
nuts, inner seals and outer seals required to rebuild a
roller
Roller Rebuild Tool Kit:
Includes all the tools and
the installation instructions required to rebuild a roller
with the roller rebuild kit
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Adjustments
Adjusting the Bedknife to the Reel
Use this procedure to set the bedknife to the reel and
to check the condition of the reel and bedknife and
their interaction. After completing this procedure,
always test the cutting unit performance under your
field conditions. You may need to make further
adjustments to obtain optimal cutting performance.
Important:
Do not overtighten the bedknife to the
reel or you will damage it.
•
After backlapping the cutting unit or grinding the
reel, you may need to mow with the cutting unit for
a few minutes and then perform this procedure
to adjust the bedknife to the reel as the reel and
bedknife adjust to each other.
•
You may need additional adjustments if the turf is
extremely dense or your cutting height is very low.
You will need the following tools to complete this
procedure:
•
Shim 0.05 mm (0.002 inch)—Toro Part No.
125-5611
•
Cutting performance paper—Toro Part No.
125-5610
1.
Position the cutting unit on a flat, level work
surface. Turn the bedbar adjusting screws
counterclockwise to ensure that the bedbar does
not contact the reel (
).
g019940
Figure 8
1.
Bedbar adjusting screw
2.
Tip the cutting unit to expose the bedknife and
reel.
8
