Toro 03693, Operator'S Manual

Page: 6 / 24

g003318
Figure 3
1. Cutting unit kickstand
3
Adjusting the Rear Shield
No Parts Required
Procedure
Under most conditions, the cutting unit produces
best dispersion when you close the rear shield (front
discharge). When conditions are heavy or wet, you
may open the rear shield.
To open the rear shield ( Figure 4 ), loosen the cap
screw securing the shield to the left side plate, rotate
the shield to the open position and tighten the cap
screw.
g003316
Figure 4
1. Rear shield 2. Cap screw
4
Mounting the Counter
Weights
No Parts Required
Procedure
All cutting units are shipped with the counter weight
mounted to the left end of the cutting unit. Use the
following diagram to determine the position of the
counter weights and reel motors.
g003319
Figure 5
1. On the #2 and #4 cutting units, remove the 2
cap screws securing the counter weight to the
left end of the cutting unit.
2. Remove the counter weight ( Figure 6 ).
6