Toro 03674, Operator'S Manual

Page: 21 / 76

6
Installing the 48 V
Disconnect Jumper and
Closing the Seat Base
No Parts Required
Procedure
1. Apply dielectric grease to the contact surfaces
of the battery disconnect jumper (
Figure 33 ).
g353655
Figure 33
1. 48 V system connector 2. Battery disconnect jumper
2. Plug the battery disconnect jumper into the 48 V
system connector.
3. Rotate the seat and seat base closed, and latch
the base (
Figure 34 ).
g379173
Figure 34
1. Latch (seat base)
7
Installing the CE Hood Lock
Parts needed for this procedure:
1 Hood lock, seal, and jam nut
1 Washer
Procedure
1. Unlatch and raise the hood.
2. Remove the rubber grommet from the hole in
the left side of the hood (
Figure 35 ).
g027072
Figure 35
1. Rubber grommet
3. Ensure that the seal is assembled to the hood
lock (
Figure 36 ).
21