Toro 03248, Installation Instructions Manual

Page: 5 / 8

5
Installing the Switch Panel
to the Sunshade Frame
Parts needed for this procedure:
4 Carriage bolt (#10 x 1/2 inch)
4 Flange locknut (#10)
6 Cable tie
Assembling the Switch Panel to
the Sunshade Frame
1. Align the square holes in the switch panel with
the square holes in the 2 side-frame channels of
the sunshade as shown in
Figure 8 .
g245153
Figure 8
1. Carriage bolt (#10 x 1/2
inch) 3. Square hole (switch panel)
2. Square hole (side-frame
channel) 4. Flange locknut (#10)
2. Assemble the switch panel to the side-frame
channels (
Figure 8 ) with the 4 carriage bolts
(#10 x 1/2 inch) and 4 flange locknut (#10).
3. Torque the flange-locknuts to 419 to 513 N∙cm
(37 to 47 in-lb).
Routing the Wire Harness
1. Route the wire harness of the switch panel kit
along the roll-bar tube as shown in
Figure 9 .
g245157
Figure 9
1. Roll-bar tube 3. Cable ties
2. Kit wire harness
2. Secure the wire harness to the roll-bar tube with
the cable ties as needed (
Figure 9 ).
6
Installing the Sunshade
No Parts Required
Procedure
1. Align the holes in the grommets of the sunshade
with the 4 clipnuts of the side-frame channels.
2. Assemble the sunshade to the frame channels
(
Figure 10 ) with the 4 flange-head bolts (5/16 x
1-1/4 inches) and 4 washers (5/16 inch) that you
removed in
2 Removing the Sunshade (page 2) .
5