Toro 03248, Installation Instructions Manual

Page: 2 / 8

1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Shut off the engine, engage the parking brake,
and remove the key from the ignition switch.
3. Disconnect the battery; refer to the electrical
system maintenance section of your
Operator’s
Manual .
2
Removing the Sunshade
No Parts Required
Procedure
g244329
Figure 1
1. Sunshade
1. Remove the 4 flange-head bolts (5/16 x 1-1/4
inches) and 4 washers (5/16 inch) that secure
the sunshade to the side-frame channels (
Figure
1 and Figure 2 ).
Note:
Do not remove the grommets from the
sunshade.
g244328
Figure 2
1. Grommet 3. Washer (5/16 inch)
2. Flange-head bolt (5/16 x
1-1/4 inches) 4. Clip nut (side-frame
channel)
2. Remove the sunshade from the machine ( Figure
1 ).
3
Preparing the Switch Panel
Parts needed for this procedure:
1 Decal
1 Switch panel
Installing the Decal to the Switch
Panel
1. Carefully remove the backing from the decal
(
Figure 3 ).
2