Usage:
Fan operation:
Always operate the fan in the upright position
following all instructions and recommendations listed in this
manual.
Fan location:
Place the fan in the area of the room that will
provide proper fan cooling.
Fan connection:
Plug fan directly into 120 volt A.C., 60 Hz wall
outlet. Be sure plug fits tightly in outlet. A loose connection may
cause overheating and damage to the plug or fan.
Note:
To prevent overloading a circuit, do not plug the fan into a
circuit that is servicing other electrical needs.
Speed control:
Select air speed by setting switch to either
low-medial-high-off.
•
OFF
•
LOW
•
MED
•
HIGH
Care and Maintenance
Cleaning:
CAUTION-Before cleaning the fan be sure to
disconnect power cord from the plug. Clean the grille surface
with a clean damp cloth. Do not use harsh chemical or abrasive
cleaners. DO NOT IMMERSE THE FAN OR ANY WIRES IN
WATER. Replace front grille before fan use. Allow fan to dry
completely before use. Periodic grille cleaning with a vacuum will
prevent dust build up. The motor is sealed and does not require
any interior maintenance, cleaning or lubrication.
Maintenance:
The Internal motor bearings are permanently
lubricated at the factory and do not require any additional
lubrication.
Repair:
DO NOT OPERATE THE FAN WITHOUT THE GRILLE IN
PLACE. DO NOT USE THE FAN IF IT HAS MALFUNCTIONED OR
BECOME DAMAGED IN ANY WAY.
Storage:
Keep original carton for storage of the fan. Coil and tie
the power cord to avoid damage during storage.
This product employs overload protection (fuse). A blown
fuse indicates an overload or short-circuit situation. If the
fuse blows, unplug the product from the outlet. Replace the
fuse as per the user servicing instructions (follow product
marking for proper fuse rating) and check the product. If the
replacement fuse blows, a short-circuit may be present and
the product should be discarded or returned to an
authorized service facility for examination and/or repair.
Fuse Replacement:
SETTING OSCILLATING MODE
1. TO MAKE THE FAN OSCILLATE: Press down the
oscillation knob at the top of the fan head
.
(See Figure A.)
2. TO STOP THE FAN OSCILLATE: Pull up the oscillation
knob at the top of the fan head.
(See Figure
B
.)
。
1. Grasp plug and remove from the receptacle or other
outlet device. Do not unplug by pulling on cord.
2. Open fuse cover by sliding open fuse access cover on
top of attachment plug towards blades. See Fig. 2.
3. Remove fuse carefully. Use a small tool to pry the end of
the fuse from holder cavity. Be careful not to break glass
window.
4. Replace fuse. WARNING: Risk of fire. Replace fuse only
with identical 2.5 or 5.0 Amp, 125 Volt fuse (3.6mm x
10mm).
Be sure fuse is properly seated within its cavity.
5. Close fuse cover by sliding it back to its original closed
position.
Fig 1
Fig 2
Fig 3
EXTENDING THE STANDING POLE
Loosen the
height adapter
on the standing
pole .
Then pull the
upper
inner tube
of the standing
pole to the
desired height
and re-tighten
the height
adapter
