1N00-610 Genesis Super Truck v1.0 03/04
To change the receiver proceed as follows:
Release the retaining strap catch by rotating the catch in either direction one
quarter of a turn. Rotate the retaining strap away from the receiver case.
Disconnect and remove the battery. Release the battery cable from it’s
retaining clip.
Disconnect the motor connector over the gearbox (Diagram 2.23). Release
the motor cable from it’s retaining clip.
Lift the rear of the receiver and remove it from the chassis.
To replace the receiver reverse the above procedure. Ensure that the steering
arm is correctly inserted into the
black track rod moulding and that
the receiver is set to the correct
model number.
2.26 Fitting the Battery to the Chassis
Tip!
This section contains information regarding the fitting of batteries into the
chassis. For information about the batteries themselves and how to charge
them see the section 2.21 the Batteries.
To fit the battery into the chassis,
carefully place a fully charged battery
into the chassis in the position indicated
by the diagram. Then with the model in
the operating area and the wheels clear
of the ground connect the Orange battery
lead to the battery, being careful to align
the connector with the correct socket.
Note!
The battery should not be connected to the receiver unless the model is in the
operating area and the consoles turned on.
Caution!
The model must not be placed on an elevated surface (table or work
surface)with the battery connected. In the event of an uncommanded
movement of the model it could drive off the surface and fall to the ground.
This will almost certainly result in severe damage to the model and possible
personal injury.
To remove the battery from the model proceed as follows. With the model in
the operating area remove the body. Disconnect the battery from the receiver
by gently pulling on the connecting plug.
©Tornado International Ltd. 2004
-25-
Confidential
