Page 2
NOTE: Adjustment of the airspring pressure, either up or down, is recom-
mended to obtain the best handling and ride quality. Air pressure will vary
depending on your particular application.
On some applications, after lowering your airbag pressure, a small gap may
remain between the overload spring and the stable load. This is acceptable. It
is not necessary for the stable load to be in continuous contact with the over-
load.
-ADDENDUM-
In order to eliminate the slapping noise some customers may experi-
ence. Cut the lower portion of the stable load off to reduce the surface
contact area. You will want to cut it off parallel to the main plate and
approximately 3/16” below the seam line. See attached pictures.
*NOTE TORQUE STABLE LOAD HARWARE TO 40 FOOT POUNDS.
Our Stableloads are intended to be used with
the factory overload spring suspension and not
intended to be used with aftermarket springs
and Overloads.
