In order to switch to manual control, it is necessary to enter with the operator password for safety reasons. When the correct
password is entered, manual control is started and on/off would be possible.
After entering the correct password, the control screen will open. By pressing the OK button, the on/off command can be given. To
exit manual control, press the MENU button. Otherwise the product will remain in manual control and will not respond to external
commands.
i. Temperature Settings
SSB gives a warning when the temperature value of the actuator which it is connected out of the specified values. These limit values
can be determined by the user. In case the temperature change is sensitive, the limit temperature values need to be updated. In this
case, the Temperature Settings tab should be selected in the Settings screen.
Select one of the lower and upper limit tabs using the arrow keys. Press OK to select the limit value screen. After the selection is made,
it is set to the desired value by using direction buttons. Press OK to save. When the measured temperature values are outside the
specified values, it starts to give warning.
j. Warnings
The warning led lights up in any fault and error condition in the actuator or SSB. If the warning light is lit, warning reason can be seen
on the warnings screen. Alert deletion is not performed. Alerts continue to be displayed on this screen during the time the warning is
in progress. However, if the problem that caused the warning is removed, the warning will be removed.
Figure 29:
Manual control password entrance screen
Figure 30:
Manual control screen
Figure 31:
Temperature limit setting tab
www.smstork.com
15
valve & automation
Summary of Contents for Smart Switch Box
Page 21: ...www smstork com ...
