Now press
ENTER
briefly and everything in the
timer memory will be erased, including real time
and date.
NOTE:
Unit has permanent memory
and will not be erased unless done through pro-
cedure above.
4. Upon powering up your timer the display will
show at what frequency the unit is operating, 50
will determine 50Hz or 60 for 60Hz.
NOTE:
While in the AUTO mode, if AC power is absent,
the display will show a “PF” (power failure)
instead of the seconds scrolling up.
5. A “Lo” on the display indicates that the super
cap has run low and the unit needs to be pow-
ered with AC. A minimum of 8 hours is required
to fully charge the super cap.
9
NOTE:
AFTER MAKING ANY CHANGES TO THE
PROGRAM, PRESS
MODE
TO GO TO RUN MODE
AND THEN PRESS
EVENT
TO UPDATE THE LOAD
STATUS.
EWZ101_120single 7/25/07 10:18 PM Page 11
