NOTE: Since daylight savings was previously set, we
have to review the block holiday entries to find it and
modify it.
Press ENTER continuously until the daylight savings
start date is displayed with a bar over the ON symbol.
While RVU is flashing, press ADVANCE twice. The
month digits will begin to flash and RVU will stop flash-
ing. Press ADVANCE to modify the start month. Press
ENTER.
The date digits are flashing. Press ADVANCE to
change it. Press ENTER.
The daylight savings end date is now displayed and
RVU flashes again. To change it, press ADVANCE
twice. The month digits will begin to flash and RVU will
stop flashing. Press ADVANCE to modify the end
month if necessary. Press ENTER.
The date digits are flashing. Press ADVANCE to modi-
fy it. Press ENTER.
Press RUN/SET to exit to the Run mode.
4.0 TO SET STANDARD ON/OFF SCHEDULE
From the Run mode press the RUN/SET key to go to
the Set modes. Press ADVANCE until the SCH/RVU
symbol is flashing (in lower left corner of display). The
display shows
11
E
SU MO TU WE TH FR SA H1 H2
HOLIDAY
TIME/DAY
DATE
SCH/RVU
RVU
SET
LATITUDE
SUNSET
SUNRISE
ON
A
SCH.
SIGNAL
OFF
B
9
SIG. TIMER
SU MO TU WE TH FR SA H1 H2
AM
HOLIDAY
TIME/DAY
DATE
SCH/RVU
SET
LATITUDE
SUNSET
SUNRISE
ON
A
SCH.
SIGNAL
OFF
B
10
SIG. TIMER
Press ENTER.
“C1” will begin to flash. If you desire to program chan-
nel 1, press ENTER. If channel 2 is desired, press
ADVANCE and the display will flash “C2”. Press
ENTER.
The bar under Sunday is now flashing. Select the days
you want operation by pressing ENTER when the bar
appears under the day. Press ADVANCE to pass the
days that you do not want operation.
After selecting the days of the week, the bar under H1
will begin to flash. If your present setting is to occur on
all single-day holidays, press ENTER to select H1. If
not, press ADVANCE to pass it.
The bar under H2 is now flashing. If the present setting
is to occur on all block holidays, press ENTER to
select H2. If it is
not
to occur on any block holiday,
press ADVANCE to pass this selection.
NOTE 1: Holiday schedules can be programmed sep-
arately if desired. Simply select H1 or H2 as
the day selection when setting your sched-
ules. (See Section 7.1)
NOTE 2: If no holiday dates are programmed, you can
ignore H1 and H2.
NOTE 3: If a single or block holiday is programmed
and no schedule is entered for it, then NO
OPERATION will occur during the holiday.
The last operation before the holiday (whether
ON or OFF) will remain throughout the holiday
period.
The hour dashes are flashing. Press ADVANCE to
program the hour desired. (Note AM/PM.) Press
ENTER.
The minutes are flashing. Press ADVANCE, if needed,
to modify the minutes. Press ENTER.
The bar over the ON is flashing. Press ENTER if this is
the desired operation. If not, press ADVANCE to flash
the OFF. Then press ENTER.
12
