12.
For TX-2 and TX-4 models
position the End
Cover (13) against the Housing and after applying a
non-permanent thread-locking compound to the
threads, install the End Cover Screw (14).
13.
Wrap the threads of the Swivel Sets (20) with
Teflon tape and thread the swivel with the male hose
Coupler (21) into the threaded hole in the End Cap.
14.
Apply some Marine Moly Grease to the notch in the
Piston Rod and the face of the Sliders.
Assembly of the Tool
1.
With the Cylinder Assembly in one hand and the
Ratchet Link in the other, hook the notch on the shaft
of the Piston Rod (3) onto the Drive Pin (4) and bring
the two assemblies together.
2.
Insert the Link Pin (12) into the hole in the Side Plate
(1 or 2) until the Ball Plunger (15) snaps into the
annular groove around the center of the Link Pin.
17/20
