TORAY MBR
Instruction Manual
06-G-MB2-NHPAC-220801
29 of 61
Never lift or operate the module with worn or damaged parts. Use
chains or slings rated for the weight being lifted. Check the
condition of each part before lifting.
Prior to lifting, make ready a flat area to set the module down. This
will minimize the potential for damage. Damage will occur if the
module is allowed to tip over.
Do not apply a strong force to polypropylene air diffuser and filtrate
water manifold when moving the module. Otherwise, the air
diffuser and filtrate water manifold may get damaged.
3. Checking Products
Upon arrival of the “NHPA Series”, immediately check the following:
(1) Make certain all items are delivered as stated on the shipping documents.
(2) Check to make sure no damage was inflicted during transport.
(3) Check to confirm that the protective covers remain in their correct position.
(4) Check to confirm that all the filtrate tubes are surely connecting elements and
manifold.
4. Storing Products
"NHPA Series" has to be stored indoors under lower than 40 deg C of the temperature. If the
“NHPA Series
”
cannot be stored indoors due to prevailing construction site conditions, try to
minimize the time being out of doors. As soon as possible, move the “NHPA Series” into a
protected area to avoid accidental damage. Always comply with all recommended storage
conditions.
At all times during transportation and installation of the “NHPA Series”, protect the
module elements and other components from damage. Take special measures to
protect the elements from sparks caused by welding, fusion cutting, or grinding.
If any
of these activities are in progress, be sure to protect the elements by using fireproof sheets
or other protective materials.
(1) Keep the module upright at all times and do not place any heavy objects on the
module.
(2) Maintain the temperature below 40 deg C.
(3) Prevent from freezing.
(4) Prevent from getting wet. Avoid conditions where condensation may occur on the
module or elements.
(5) Do not submerge in water until such time as the “NHP210 Series” is ready for final
installation.
(6) Avoid module exposure to direct sunlight.
(7) Protect from falling objects. Again, avoid exposure to sparks from grinding or welding.
DANGER
!
DANGER
!
DANGER
!
