TK218 OBD-II GPS Tracker
User Manual
Page 9
It is to set the time interval of the tracker's heartbeat packet, default:3minute. Maximum:
65535 minutes.
Clear Data Logger
******NUL
111111NUL
It is to clear the offline GPS data in the data logger
Check the Gprs Setting
******WWW
111111WWW
It is to check the GPRS settings.
Set the threshold of
smart engine detection
******ACC:X
111111ACC:13.0
The default setting is 13.0. For big truck, it is suggested to set as 26.0. User can send
111111ADC to check the real value. the last number in the feedback SMS is vehicle's voltage.
Check firmware version
& IMEI, others
PAR
PAR
It is to check the firmware version, IMEI, device ID GPRS settings, time zone.
Read vehicle VIN no.
******VIN
111111VIN
It is to read out the vehicle's VIN no. from CANBUS. The command works only when the OBD
module is not in sleep mode
Reset fuel consumption
******OIL
111111oil
It is to reset the fuel consumption value of CANBUS data. The command works only when the
OBD module is not in sleep mode
Read & clear error code
******ERR
：
& ******ERR
111111ERR
：
111111ERR
：
it is use to read the error code.
(with
：
at the end of the command)
111111ERR
it is to clear the error code .
(without
：
at the end of the command)
Adjust harsh brake &
acceleration threshold
******USP:X
******DSP:X
111111USP:30
111111DSP:70
X: is the speed(km/h), value range: 0~100 Km/h
If the change of car speed is larger than X between 2 seconds, it will be triggered as harsh
brake or harsh acceleration.
******USP:X
: to set the threshold of harsh acceleration
******DSP:X
: to set the threshold of harsh brake
