BEGIN RAISING TENT BY
PROPPING UP THREE LEGS.
Step 4
: Install any three legs in succession. Attach
cam buckle straps by clipping one end to the ring on
the corner of the top and looping the other end over
the tab on the leg base. Pull snug.
Step 5
: Raise top as shown in Step 4 and install center
pole by placing pin through the reinforced hole in the
tent top. Next, place the center pole base with roller
on the top cable. Roll the base toward the center
while pushing upward on the center pole. Complete
center pole installation by pushing the remaining two
cables under their respective grooves in the center
pole. Use D-Clasp pin supplied with the center pole to
secure the cables to the center pole base.
Note:
If using a flag, it should be installed on the
center pole prior to raising.
CENTER POLE
TENSION
CABLES
Sierra Hexagonal Tent Installation Instructions
Step 3
: Lay out top over frame and cables making
sure loose portion of top stays in the center. Pull
corners of the top over the frame corners and pull
the web loop over the tab of the corner bracket.
LAY TOP OUT
Step 6
: Continue raising tent by installing remaining
legs in succession. Attach cam buckle straps at each
leg location to pre-tension the top.
Sierra Hex
Form # 20040813
