Toppro T-link8, User Manual, Page: 7 / 8

9. BALANCE / PAN control
Generally, the main section uses the stereo input and output, while, for each individual channel, mono
application is configured. So, if the stereo main signal is split into the mono channel output, or the mono
input signal is routed to the stereo main output bus, please use this knob to determine the proportion
between the left and the right.
10. POWER SWITCH & POWER LED
This switch turns on/off the unit. When the unit is powered on, the LED will light up.
11. FUSE HOLDER
Before you attempt to connect and operate the unit, please make sure that your local voltage matches
the voltage on the fuse-holder cover.
a
qualified blow
after replacing,
Caution: The fuse protecting the AC supplies circuits of this unit. The fuse can only be changed by
technician, in the event of a fault or changing the supply voltage. If the fuse continues to
discontinue use of this unit before repaired.
12. AC inlet
This connector is meant for the connection of the supplied main cord. Do not insert power cable
into the unit until the voltage has been correctly set. Do not plug power cable into AC power until
voltage has been correctly set.
13. MAIN INPUTS
These two XLR balanced connectors are used to input the main stereo signal. In SPLITTER mode, it can
be split into each mono channel output.
11 12 13 14 15 16
6
T-link8
14. MAIN OUTPUTS
These two XLR balanced connectors are used to output the main stereo signal. By depressing the
MAIN LINK, It can be linked with the MAIN IN directly.
15. INPUT for the mono channel
For Channel 1~4, use the XLR balanced connectors to input the mono signal, while, for Channel
5~6, please use the TRS type.
16. OUTPUT for the mono channel
For Channel 1~4, use the XLR balanced connectors to output the mono signal, while, for Channel
5~6, please use the TRS type.
9
T-link8
This is a dual voltage unit. Please ensure that the T-LINK8
Do not insert power cord into the unit until voltage has been correctly set. Do
The mains connection of the T is made by using the
is set to the correct supply voltage
before plugging the power cord into the wall outlet, use the same fuse as marked on the fuse
holder at the AC power connection socket.
not plug the
power cord into AC power until voltage has been correctly set.
-LINK8 enclosed mains cord and a standard
IEC receptacle. It meets all of the international safety certification requirements.
Either the 1/4" TRS (Tip-Ring-Sleeve) phone jack or the XLR servo connector can be wired in
balanced and unbalanced modes, which will be determined by the actual application status, Please
wire your systems as the following examples:
The T-LINK8 presents with balanced XLR connectors and 1/4" TRS phone jack, it can be interfaced
by several ways to support a variety of applications without any signal loss.
TRS Type Unbalanced
Tip
Ring
Sleeve
+
Mains Connection
Audio onnection C
a. Wiring Configuration
For 1/4" Phone jack
TS Type Unbalanced
TRS Type Balanced
Tip
Ring
Sleeve
+
-
Sleeve
Tip
+
For XLR connector
XLR Type Unbalanced XLR Type alanced B
Pin3 (-)
Pin2 (+)
Pin1 ( )
(Linked to Pin1 manually, )
Pin1 ( )
Pin2 (+)
Pin3 (-)