9
9
1
2
1
1
1
2
2
2
2
1
7
MAST
continued
C. Attach the shroud wires (coated in white plastic) onto the
chain plates on either side of the boat
(3)
Use the third hole from
the bottom of the chain plates.
(4)
Then secure chain plates to
the hull as shown.
D. Lay trapeze wires to either side of the mast, so that they are
roughly in the correct position ready to be attached once the
mast is upright.
E. Next is the jib halyard, the jib halyard comes in two parts
(5)
.
Ensure one section is fed through ring
(6)
and small pulley
(7)
on forestay.
F. Then feed end of spinnaker halyard through the small pulley at
the top of the mast
(8)
.
G. Take spinnaker halyard to foot of mast tying ends together to
create a loop.
H. Position mast so that the foot of the mast is on the ball joint
on the front beam and secure in place with pin.
E. Attach striker bar
(9)
(front cross bar) between the hulls at front
of boat.
ENSURE THAT THE
STERN OF THE BOAT IS
FACING INTO THE WIND.
ENSURE THAT THE
MAST IS CLEAR OF
ANY OVERHEAD
CABLES OR
OBSTRUCTIONS!
Re-tidy all of the rigging.
You are now ready to
raise the mast. This is a
two person job.
E. Person One
(1)
should
be positioned towards
the front of the boat
holding the trapeze wires.
Person Two
(2)
should
support the top of the
mast behind the boat
and then walk mast
forward until it is upright.
3
4
6
7
8
5
