5
LOW NOISE PR
EA
M
P
MIC IN (bal )
.
LOW
DSP/FX
AUX1
POST
80Hz
LINE IN(bal )
.
12KHz
HIGH
2 5KHz
.
MID
SG/PEAK
15
-15
0
15
-15
0
-12
12
10
-
LEVEL
-
8
10
0
8
1
2
3
4.1 FRONT PANEL
1
LEVEL CONTROL
This control is used to adjust the overall level of the respective channel.
The adjustable range goes from -
to +10dB.
5
MID
This is the mid range control. It can affect most fundamental frequencies
of all musical instruments and human voice. An attentive use of this control
will give you a very wide panorama of sound effects. The gain range goes
from -12dB to +12dB and the center frequency is 2.5kHz.
7
6
3-BAND EQUALIZER
3-band equailizer is provided for all input channels with a wide range of
frequency adjustment.
LOW
8
2
MONO INPUT CHANNELS
This is the bass control. It is used to boost male voice, kickdrum or bass
guitar. Your system will sound much bigger than what it is. The gain
goes from -15dB to +15dB and the center frequency is 80Hz.
CH1 TO CH 4(TPM6250MKII CH1 to CH6,TPM8250MKII CH1to CH8)come
with balance MIC IN and LINE IN connectors.Use the XLR (MIC IN)socket
to connect low impedance microphone or low level signal,which also
fe15V phantom power allowing you to connect a condenser
microphone. Use the 1/4" TRS(LINE IN)jack to connect either a microphone
or a line instrument such as synthesizers, drum machines, effect processors
or any other line level signal.
+15V PHANTOM POWER SWITCH AND WORKING INDICATOR
This switch will apply +15V Phantom power only to the XLR sockets. When
these XLR sockets are connected with devices that not require phantom
power, please make sure the phantom power is turned off, failure to close
may damage the device.
When pressing phantom power switch, the indicator lights up; it means
that phantom power is working, When pressing phantom power switch
again, the indicator is extinguished.
DSP/FX AUX POST CONTROL
This control is configured as POST-FADER, so the audio signal will be
affected by channel level control. Via the FX SEND socket, the AUX1
signal can be an external effect device.
4
3
PEAK/SIGNAL LED
This LED will illuminate green when there is a signal present in the
LINE/MIC input. When signal nears clipping the LED will turn to red.
Note: you shall never connect an unbalanced microphone to the XLR socket if
you do not want to damage both the microphone and the mixer.
HIGH
This is the treble control. You can use it to get rid of high frequency noises
or to boost the sound of cymbals or high harmonics of the human voice.
The gain goes from -15dB to +15 dB with a center frequency of 12kHz.
TAPE IN
TAPE OUT
PHANTOM
LEVEL 7-8
-
8
10
Summary of Contents for TPM 4250 MKII
