Shenzhen TOPFLYTECH Co., Limited. All Rights Reserved 9
working voltage of relay before connecting.
6.
Cautions of Tracker Wiring
6.1
Power Supply Cable (Refer to the diagram on page 5)
6.1.1
Standard working voltage of the tracker is 7V to 32V DC. Please use the original
cables. The red cable is +, the black cable is -.
6.1.2
Orange cable(ACC) connects to the ignition switch of vehicle. It will enable the
tracker to know the exact status of the vehicle.
6.1.3
The yellow cable connects to the cable with the same color of the relay. Fasten
the relay tightly at a dry place. It is recommended to cover the relay with a plastic
bag for protection.
6.2
RS232 Connector
Connect to RS232 accessories.
7.
Tracker Configuration
Refer to frequently used operation commands in this manual
8.
Tracker Operation
8.1
Power on and off
8.1.1
Power on: Insert a SIM card and connect the tracker to external power. It will turn
on automatically.
8.1.2
Power off: Remove the SIM card first, then disconnect the tracker from external
power. It will power off automatically around 5~10 seconds.
8.2
Location Search
8.2.1
Dial Query
Dial the tracker. Hang up in 10 seconds after ringing. Then the location
information will be sent to you through SMS. But if hold on more than 10 seconds,
it will enter the listen-in mode.
8.2.2
SMS Query
Send a location inquiry SMS command (refer to the Operation Command in this
manual) to the tracker. The location information will be sent to you through SMS.
8.2.3
Platform Query
Connect your tracker to the tracking platform then check the real-time position
online. (Additional tracking service charge may happen. Contact with your service
provider to get more details.)
8.3
Fuel Supply Cut
Fuel supply cut command can be sent from tracking platform or through SMS when
needed. To make sure the vehicle safety, tracker will cut off the fuel supply only when the
vehicle is positioned, and the speed is lower than 20Km/H. (If the vehicle speed is higher
than 20Km/H or the vehicle is
n’t
positioned, the tracker
will return “SET RELAY DELAY,
SPEED IS MORE THAN 20KM/H#” or “SET RE
-
LAY DELAY, GPS UNFIXED#”
and will keep
