Shenzhen TOPFLYTECH Co., Limited. All Rights Reserved 8
4.2
Power(Blue)
Fast Blink
External Power Disconnected
Slow Blink
External Power Connected
4.3
GNSS(Red)
Fast Blink
Satellite Searching
Slow Blink
Positioned
Note:
1)
Indicator lights will go out automatically after the tracker turn on for 5 minutes.
2)
If you want to check the working status, dial the tracker. Then the indicator lights will begin to
blink. After 5 minutes, the lights will go out again.
3)
Slow Blink: Last for 3 second, then go out for 1 second.
Fast Blink: Last for 1 second, then go out for 1 second.
5.
Installation Guide
5.1
SIM Card Pre-Installation Note
5.1.1
GPRS data service should be enabled.
5.1.2
Telephone enquiries function will work only when Caller ID function is enabled.
5.1.3
If SIM card is locked via PIN, please unlock it first.
5.1.4
Ensure there is sufficient balance in the SIM card.
5.2
Installation
5.2.1
Ask the technician recommended by your dealer to do the installation. Ensure the
tracker top side (with TOP SIDE logo on) face upward. Fix the tracker with our
standard double-side adhesive tape.
5.2.2
Note:
1)
Install in hidden place to prevent theft or damage.
2)
Away from emission source such as all kinds of sensors, burglar alarm and
other communication devices.
3)
There is a sponge double-side adhesive tape as standard accessory for this
product. Make sure the destination surface clean, dry and smooth before
attaching. The stickiness will be better after 24 hours. Or use wire/cable to
fasten the tracker tightly.
4)
Tracker has built-in antennas. Please ensure the top side (with TOP SIDE logo
on) towards to a window (sky) and not shielded by metallic things.
Recommend location:
-
Under the plastic cover of console panel behind the front window.
-
Beneath the plastic cover of back window.
5.3
Relay Installation
The white cable connects to ACC cable of the car, the yellow cable connects to the relay
control cable of the tracker with the same color. Refer to the diagram on page 5.
Note: Check the vehicle battery voltage (
usually it’s
12V or 24V) and ensure it equal to the
