TOPEX BYTTON HSDPA
User’s Manual
pag. 12
Perform the following steps:
- mark on the wall the position of a pair of holes,
spaced at 160 mm apart
- drill the holes in the wall
- forcibly insert into the holes the plastic dowels
- thread the metallic woodscrews into the plastic
dowels leaving the end to protrude outside for
some 5 mm
- hang the case of BYTTON HSDPA in the two
metallic woodscrews and push it down a little to get
it fixed
- if it does not lock properly, you should adjust the
screws
Figure 1. Mounting BYTTON HSDPA on a wall
No matter if it is installed horizontally or vertically, the best location for BYTTON HSDPA is in the
middle of the place where you want to have wireless coverage. Installing BYTTON on a shelf higher up,
with no obstructions around, ensures the best performance, both for WiFi and for the HSDPA modem.
Take care to ensure adequate cooling of the Bytton terminal.
4.3 Identification of connectors
Topex BYTTON HSDPA features several external connectors, as described below.
On the back panel of the equipment there are, from left to right:
Figure 2: Connectors of BYTTON HSDPA
a circular RF connector (female), for the HSDPA antenna
(labeled GSM/3G)
a RJ-11 connector for the FXS telephone interface
(labeled FXS1)
another RJ-11 connector for the FXO telephone interface
(labeled FXO)
the slot for the SIM card (
labeled SIM
)
in the middle, a little below the centerline, a second RF connector (male) for the antenna of
the 802.11 b/g wireless access point
(labeled WiFi)
the black Reset button, recessed (
labeled RST
)
the USB-A slot (
labeled USB
)
A RJ45 connector for the external network (
labeled WAN)
four female RJ45 connectors for the local network connections,
(labeled LAN4 to LAN1)
;
the four LAN connectors are numbered in reverse order, as to correspond to the LAN
indicators on the opposite side, which are direct order.
The right, the round connector for the power supply jack, (labeled
PWR)
(12V
DC
)
