3
Programming the Keypad
NOTE: There are two kinds of codes while programming: Master code and Entry code. The master code is
used to program the keypad.The entry code is used to activate the keypad to control the gate opener. You
can program the temporary codes and the permanent entry codes according to your needs. The use
number of times of the temporary entry codes can be programmed at the same time.
NOTE: Max. 32 permanent entry codes and 32 temporary codes can be programmed to the keypad.
NOTE: All codes should be 4 digits in length. Factory default master code is 9999.
Program New Master Code
SET 4 digits Old Master Code SET 01 SET 4 digits New Master Code SET 4 digits New Master Code SET
Add New Permanent Entry Code
SET Master Code SET 02 SET Entry Code SET Entry Code SET
Change Permanent Entry Code
SET Master Code SET 03 SET Old Entry Code SET
New Entry Code SET
New Entry Code SET
Add New Temporary Entry Code
SET Master Code SET 04 SET Entry Code SET
2 Digits Use Number of Times SET
Delete Single Entry Code (Permanent Entry Code or Temporary Entry Code)
SET Master Code SET 05 SET Entry Code SET
Delete All Temporary Entry Codes
SET Master Code SET 66 SET
Delete All Entry Codes (Include Permanent Entry Codes and Temporary Entry Codes)
SET Master Code SET 77 SET
Program the Keypad to the Gate Opener (Wireless Application)
Step 1: Input the entry code of the keypad when it’s in standby mode.
Step 2: Press and release the
remote control programming button (CODE SW button, LNSW button, Learn
button, etc.)
on the gate opener control board, the
CODE
LED (
REM
LED,
LEARN
LED,
LCD, etc.
) will be ON or
indicate the programming display
.
Step 3: Press the A or B key of the keypad
two times
in 2 seconds, the
CODE
LED (
REM
LED,
LEARN
LED,
LCD, etc.
) will flash for 3 seconds and then to OFF or standby display. Now the keypad has been programmed to
the gate opener successfully.
Use the Keypad to Operate the Gate Opener
You can input the valid entry code and then press key A or key B which has been programmed to the control
