18
Similarly, the Soft Stop Period (SPP) can be shortened through extending the Fast Running Period (FPP).
E.g.
When the Soft Start Period (STP) is set at 3 sec, and the GRP is 23 sec, how can we get 4 sec of Soft Stop
Period (SPP) to meet the requirement? The answer is clear, i.e. we may set the Fast Running Period (FRP) at
16 sec (23 – 3 – 4 =16 sec).
12. Return to Factory Set
When the Digital Display indicates “Pd”, press and release the “INC” or “DEC” button. All data will return to
factory set, the Digital Display indicates “dF”.
13.
If all of data is set and no other change needed, press “FUNC” Button. “- -” appears on the Digital Display,
and the opener enters standby mode.
Indicate Illustration on the Digital Display When Gate Opener is Running
The left image on Digital Display symbolizes motor of gate opener 2 when the gate opener is running. The right
image on Digital Display symbolizes motor of gate opener 1.
When the motor is run to gate -open direction or gate -close direction, the image on Digital Display indicates “n”
or “u” respectively.
When the motor is not running, the Digital Display indicates
“- -”.
Adjusting the Limit Switch
Adjusting the Limit Switch of Actuator 1
The position of Limit Switch A was
fixed in factory, do not adjust it again.
Plug on the power to running gate
opener, use a screwdriver to loose the
screw of Limit Switch B, slide Limit
Switch B to the desired closed position
and fix it.
Limit setting for Gate 1 is finished now.
NOTE:
Always place the magnetic ring between the Limit Switch A and B.
Adjusting the Limit Switch of Actuator 2
The position of Limit Switch C was fixed
in factory, do not adjust it again.
Use a screwdriver to loose the screw of
Limit Switch D, slide Limit Switch D to
the desired closed position and fix it.
Limit setting for Gate 2 is finished.
NOTE:
Always place the magnetic ring
between the Limit Switch C and D.
NOTE:
The magnetic ring in the moving rod can be manually placed between both Limit Switches in each
actuator by releasing the clutch.
How to Operate
The user may operate the opener once all adjustment setting is finished.
With the gate in its closed position, press and release the remote control, the gate will move to the programmed
opening position and stop.
Summary of Contents for KD702
