6
2). Make sure there is 1” distance at least between the wheel cover and the gate after you position the base
plate.
Caution:
*Be sure that the opener is installed in a level
and paralleled position. Improper installation
could result in property damage, severe injury,
and/or death.
* Before starting installation, ensure that there
is no point of friction during the entire
movement of the gate and there is no danger
of derailment.
* Ensure that the safety side rollers are
present.
Necessary Tools:
The following tools may be
necessary to install the Gate opener. You will
need screwdrivers, an electric drill, wire cutters
and a wire stripper, a socket set, and possibly
access to a welder.
When install the opener, you should build a
concrete pad to support the base plate of opener
in order to maintain proper stability.
The installation proceeds are as follows:
1.
Assemble the Base Plate and fix the Opener to
the Base Plate.
2.
Dig a hole for a concrete pad which should be
approximately 60 x 32 x 35cm (24
〞
x 13
〞
x 14
〞
).
It may protrude 10 cm (4”) above ground and 25
cm (10”) in depth underground. Increase the pad
height if necessary to protect the system from flooding, heavy snow etc.
3.
Prepare one or more conduits for the electrical cables before pour concrete. Remember that cable
conduits have to pass through the hole on the base.
4.
Pour concrete and before it starts to harden, check that it is parallel to the gate leaf and perfectly level.
5.
Mark the position of four expansion anchors according to the position of mounting hole on the base plate.
Double check your marking, move the base plate and drill the 4 holes using a 14mm (9/16”) masonry bit. Put
the 4 expansion anchors (provided) into the holes and firmly tighten.
6. Mount the base plate to the concrete Pad and firmly tighten, enabling the opener is firmly secured
on the concrete pad during the whole gate travel.
Summary of Contents for CK700
Page 5: ...3 Parts List...
