EN
14
15
This option erases the codes from the vehicle, after retrieving codes from
the vehicle and certain repairs have been carried out.
Select [Erase Codes] and press [OK], then follow the prompts on the screen
to finish the procedure.
The result may be shown as follows:
*Note: Be sure the vehicle’s ignition key is in the ON position with the
engine off.
4.2 Erase Codes
This option checks whether or not the various emissions-related systems
on the vehicle are operating properly, and are ready for Inspection and
Maintenance testing.
It can also be used to check the Monitor Run Status, and to confirm if the
repair of a car fault has been performed correctly.
Select [I/M Readiness] and press [OK].
*Explanation of terms:
•
MIL - Malfunction Indicator Light
•
IGN - The Ignition Method of the Vehicle
•
DTC - Diagnostic Trouble Code
•
PD DTC -Pending Diagnostic Trouble Code
•
MIS - Misfire Monitor
•
FUE - Fuel System Monitor
•
CCM - Comprehensive Components Monitor
•
CAT - Catalyst Monitor
•
HCAT - Heated Catalyst Monitor
•
EVAP - Evaporative System Monitor
•
AIR - Secondary Air Monitor
•
O2S - O2 Sensors Monitor
•
HTR - O2 Sensor Heater Monitor
•
EGR - EGR System Monitor
The result may be shown as follows:
4.3 I/M Readiness
I/M Readiness
HTR
This option retrieves and displays live data and parameters from the
vehicle’s ECU.
Select [Data Stream] and press [OK], then follow the prompts on the screen
to finish the procedure.
The result may be shown as follows:
4.4 Data Stream
