-19-
ArtiLink300 Code Reader User Manual
FAQ
Q: System halts when reading data stream. What is the
reason?
A: It may be caused by a slackened connector. Please turn
off the tool, firmly connect the connector, and switch it on
again.
Q: Screen of main unit flashes at engine ignition start.
A: Caused by electromagnetic disturbing, and this is normal
phenomenon.
Q: There is no response when communicating with on-board
computer.
A: Please confirm the proper voltage of power supply and
check if the throttle has been closed, the transmission
is in the neutral position, and the water is in proper
temperature.
Q: Why are there so many fault codes?
A: Usually, it’s caused by poor connection or fault circuit
grounding.
Q: Why the DTCs cannot be erased?
A: 1. Please confirm the malfunction related to DTCs has been
properly fixed.
2. Please switch the ignition OFF. Wait for 1~3 minutes,
then start the vehicle. After that, try to run “Read Codes”
again. (Some DTCs can only be erased in this way.)
