Set
tin
gs
Changing Parameters using the LCD Display
27
SRL-35 Operator’s Manual
P/N: 1003224-01
Changing Channel (Channel of the Active TX/RX Radio
with Preset Frequencies)
This is the display in
Data Transfer Mode
.
Channel number is 4
TX Power is 10W
TX/RX frequencies are 462.375
Channel spacing is 12.5 kHz
Signal strength info is displayed on the upper left-hand corner:
- current noise level e.g.
n-123
Battery level respectively on the upper right corner.
n-123 11.5V
CH4 10W
462.37500/12.5
INFO SETUP
After pressing the
SETUP
button
(
■
)
the display will show the main menu, which is a list
of modifiable parameters. Pressing the
▲▼
buttons the cursor moves upwards and
downwards. When the cursor > is placed beside the desired selection, entry into sub-
menu is done by pressing the SELECT- button.
Select Channel
Select Protocol
Select Repeater (ON/OFF)
Select FEC (ON/OFF)
EXIT
▲▼
Select
Press
▲
or
▼
until the display panel and the
cursor > points to “Select Channel” and press
”Select” to move onto the next submenu to
change channel.
Select Channel
> Ch4
10W
462.37500/12.5
EXIT
▲▼
SELECT
Press
▲
or
▼
until the desired channel is shown
and press “SET” if the channel is to be modified.
Press “CANCEL” if not modifying channel and
return to previous menu.
Select Channel
Ch4 10W
462375000/12.5
CANCEL
▲▼
SET
If channel is modified press “YES” to save settings or “NO” to discard
changes and return to previous menu.
Save changes?
NO
YES
