9
HOW TO USE
HOW TO USE
ASSEMBLY PROCEDURE
1
Attach the legs to the base.
The casters must be positioned diagonally against both the patient and the operator. To
attach the legs, use the two accessory M8 hexagonal socket bolts (with spring washers).
Securely tighten and affix the bolts.
2
Push the makeup button into the M8 hole of the leg (follow the same procedure for both the right
and the left leg).
3
Set the tabletop in place.
Set the tabletop in place so that the
φ
50mm hole (for arranging the cord) is at the opposite
side of the up-and-down switch.
To attach the tabletop, use the four accessory M6 hexagonal socket bolts (with spring
washers). Securely tighten and affix the bolts.
* Do not use any other tabletop except for the one included with the AIT-16 Instrument
Table.
4
Set the adjustable instrument table in the specified position.
There is a hole to pass the power cord through at the center of the table. When loading a
device onto the table, pass the cord through this hole beforehand.
Spring washer
M8 hexagonal socket bolt
Makeup button
