Chapter 10 – Steering Calibrations
71
Note
: Mounting bias calibration should be performed if any of the
above change or at a minimum once every 6-12 months.
It is advisable to still perform a mounting bias calibration when using
Autonomous
as the
Correction Source
, even though the screen reports
that it is not required.
Mounting bias calibration is done in a clear area well away from
obstacles. If the mounting of the receiver is not quite level, this
calibration will adjust for the actual position.
WARNING: Ensure the vehicle has sufficient space to
travel in a straight line for at least 70 m/230 ft and then
turn at each end of the wayline.
1. Select
/
Steering Options Menu
/
Auto Steer
Calibration
.
The Steering Calibration screen displays.
2. Select
MOUNTING BIAS
. If the component reports as calibrated,
still complete the calibration procedure if the receiver has not been
calibrated on this vehicle.
Note
: To calibrate for mounting bias, ‘A’ and ‘B’ wayline points
are plotted over 70 m/230 ft, driving the vehicle at 2 kph or
1.2 mph along the wayline. The operator turns the vehicle around at
Summary of Contents for AGA5495
