9
www.topazsystems.com
Back to Top
GemView 7 Tablet Display User Manual
Connect Pen to Tablet Display
If your pen is not already connected to the tablet display, follow these instructions:
1. Loop one end of the pen tether through the eye at the end of the pen.
2. Loop the other end of the pen tether through the tether hole located above the USB cover.
3. Note that the pen can lie flat in the pen holder slot, or it can stand vertically in the hole at
the right end of the pen holder slot.
Install DisplayLink Driver
Note: If you are installing the driver for a Citrix VDA machine, you should not perform
this step; continue to the section “Install GemView Tablet Display Driver”.
Download and run the DisplayLink installer from the Topaz website:
www.topazsystems.com/software/download/displaylink.exe
. This software provides
extended display functionality for the tablet display.
Configure Tablet Display for Installation
Use the Display program in the control panel to configure the tablet display for your installation
(see screenshot below). You may specify the following characteristics:
1. Resolution
Use the recommended resolution
2.
Orientation
Landscape or portrait
3.
Multiple displays
Extend these displays
4.
Alignment
Make sure that the bottoms of the monitors are aligned as shown below, and that the
tablet display (Display 2) is on the side of the main display you want to use when moving
windows from the main display (Display 1).
