IMPORTANT SAFEGUARDS
When using battery charged products, in order to reduce the risk of fire, electric shock, and/or injury to persons,
basic safety precautions should always be followed, including:
FOR YOUR SAFETY
Read all instructions carefully, even if you are quite familiar with the product.
• A damaged 240V charging unit could be dangerous. Do not use the charging unit if it appears to be damaged.
• Do not look directly into the light source or point it into the eyes of others. This can lead to retinal damage.
• Charge the battery only with the original 240 V charging unit.
• Disconnect the LED Worklight from the mains when the lamp is charged or the unit is no longer in use.
• Cease to use the LED Worklight immediately if it begins to visibly smoke or give off unusual smells.
• Do not throw the charger into fire and do not expose it to extreme heat. The charger could explode or burst.
• Do not attempt to alter or manipulate the LED Worklight charger in any way. Doing this increases the exposure to danger
significantly.
• Do not allow this product to be used as a toy. Close attention is necessary when used nearby children.
• Do not use with damaged cord ,plug or adaptor.
• Do not handle charger with wet hands.
• Do not unplug the charger by pulling on the cord.
• Never carry the charger by the cord or to disconnect from an outlet; instead, grasp the charger and pull to disconnect.
Do not pull cord around sharp edges or corners.
• Do not immerse the product, charger and cord in water or any other liquid.
• Use only the charger supplied with this product to recharge this product.
• Do not attempt to use the charger with any other product.
• The use of an extension cord is not recommended. Only plug the charger into a standard electrical outlet (240V outlet).
• Do not operate with a damaged charger and cord, or after the product has malfunctioned or been damaged in any
manner.
• Do not allow children to play with the packaging materials.
• Use this LED Worklight on a horizontal and stable surface.
If the charger is damaged, the charger must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard. This product has not been designed for any uses other than
those specified in this booklet.
FEATURES OF YOUR RECHARGEABLE LED TUBE WORK LIGHT WITH TELESCOPIC TRIPOD
Telescopic
LED Tube light
max.
height 34 cm.
Fully adjustable light head
90°
300°
12pcs LED
as side light
Selection
Switch
10W torch, 800lm
140pcs SMD
as tube light,
1600lm
Lock for
adjustable
tripod
Adaptor storage
5
SPOTLIGHT LED 20W / 1600 LUMENS
ON TRIPOD
EN
Translation of the original instructions
