21
❏
9. If mounting the O.S. .65AX, the .91 or .95V four-
stroke in one of the orientations suggested, use the
Throttle Pushrod Hole Template
on page 33 to mark
the hole for the throttle pushrod for the appropriate
setup. Otherwise, you will have to determine the throttle
pushrod hole location yourself.
❏
10. If you haven’t yet done so, determine where to
drill the hole in the fi rewall for the throttle pushrod—it
will probably have to be angled from the carburetor
arm toward the throttle servo—be certain the pushrod
will not interfere with the fuel tank or the wing (you
can temporarily set the fuel tank into position to see).
❏
11. Drill a 3/16" [4.8mm] hole in the fi rewall for the
throttle pushrod guide tube.
❏
12. Place the throttle servo in the side of the servo
tray that will align with the throttle pushrod, then bend
the pushrod as necessary to align with the servo arm.
Mount the servo and hook up the throttle using the
hardware shown—be certain to use threadlocker on
Summary of Contents for Giant F4U Corsair
Page 32: ...32 32 Components in Fuselage Components in Wing...
Page 34: ...34 34...
Page 35: ...35 Cowl Hole Template For O S 91 4 stroke...
Page 36: ...Cowl Hole Template For O S 95V...
