Toolson 3901208958, Instruction Manual

Page: 19 / 180

19 І 180
Troubleshooting
Problem Possible Cause Help
The motor does not run. Faulty motor, power supply cable or plug.
Burned out fuses.
Have the machine checked by skilled personnel. Do not
try to repair the machine yourselves as it may be danger -
ous. Check the fuses and replace them if necessary.
The motor starts slowly
and does not reach
running speed.
Low power supply voltage. Damaged
windings. Burned out capacitor.
Ask for the Electricity Board to check the voltage availa -
ble. Have the machine motor checked by skilled person -
nel. Have the capacitor replaced by skilled personnel.
Excessive motor noise. Damaged windings. Faulty motor. Have the motor checked by skilled personnel.
The motor does not
reach full power.
Overloaded circuit due to lighting, utilities
or other motors.
Do not use other utilities or motors on the circuit to which
the cutting-off machine is connected.
Motor overheats easily Overload of the motor; inadequate
cooling of the motor
Prevent overloading the motor when cutting; remove
dust from the motor to ensure an optimum cooling of the
motor
Decrease in cutting
power when sawing
The saw blade is too small (sharpened
too often)
Re-adjust the end stop of the saw unit
The saw cut is rough or
wavy
The saw blade is dull; the tooth shape is
not suited to the thickness of the material
Re-sharpen the saw blade or use an appropriate saw
blade
The work piece rips or
splinters
The cutting pressure is excessive or the
saw blade is not suited to the application
Use the correct saw blade